OPTIONAL EQUIPMENT (CONTINUED) PAGE 33
7Replace the pilot assembly (follow the instructions in step 6 in reverse order). Make sure the pilot assembly gasket is placed correctly.
8Replace the rear log shelf (see step 2). Install the logs and embers. Replace the door.
9Remove the regulator from the front of the gas control valve. Replace with the propane regulator, using the new gasket and screws included with the regulator. NOTE: Leak test this area after the heater is installed, gas is connected, and the main burner is lit.
Align the regulator gasket so it is flat and the two tabs fit through the two holes on the gasket.
ON
T | OFF | |
P | ||
O | ||
| L I | |
| PILOT ADJ |
NOTE: These holes strip easily. Use a hand screwdriver and tighten each screw evenly.
| These screws hold the | ||
VENT | regulator in place. | ||
NOTE: use the new | |||
| |||
HI | screws included with | ||
LO | the regulator. | VENT | |
|
| ||
|
| HI | |
| Phillips | LO | |
|
| ||
| Screwdriver |
| |
Regulator Gasket |
| LP (propane) regulators have a | |
NOTE: use the new gasket | |||
included with the regulator. | 11.0 2.8 stamped here. | ||
10Place the included propane label over the natural gas label on top of the gas control valve.
THIS CONTROL
HAS BEEN
CONVERTED TO
LP
11Make the gas line connection, start the heater and thoroughly
The pilot flame should impinge the top 3/8Ó of the thermopile. If it does not, you may need to turn the pilot up.
To adjust the pilot flame, remove the cover screw (and gasket) and turn the needle valve. Clockwise lowers the flame while
Thermopile
Pilot Hood
3/8Ó | Thermocouple |
ON
T |
|
| OFF |
|
| P | |
O | L | ||
|
| I | |
| PILOT ADJ | ||
Cover Screw Gasket |
|
|
|
The cover screw and |
|
|
|
gasket must be |
|
|
|
replaced to prevent gas |
| ||
from leaking |
|
|
|
Needle Valve
Micro (1/16Ó)
Standard
Screwdriver
Cover Screw
Standard
Screwdriver
