28 Maintaining Your Appliance
© Travis Industries 100-01190_000 4070326
Failure to properly maintain and inspect your appliance may reduce the performance and life of the
appliance, void your warranty, and create a fire hazard.
Daily Maintenance (while stove is in use)

Remove Ash (if necessary)

Ash removal is not required once it builds up. 1/2" to 1" of ash may be desirable because it slows the
burn rate. Generally, remove ash once it has built up over 1". Follow the directions below to remove
ash.
1 Let the stove cool completely (at least two hours after the last coal has extinguished).
2 Direct all of the ash through the grill into the ashpan. Remove the ashpan (see page
24). Place the ash into a metal container with a tight fitting lid. The closed container
of ashes should be placed on a noncombustible floor or on the ground, away from all
combustible materials, pending final disposal.
3 You may wish to remove any ash that is deposited in the combustion brick or
combustor (see page 32). This will insure proper combustor operation.

ASHES

Improperly disposed ashes lead to fires. Hot ashes placed in cardboard boxes, dumped in back yards,
or stored in garages, are recipes for disaster.
Wood-burning stoves are inherently dirty. During cleaning have a vacuum ready to catch spilled ash
(make sure ash is entirely extinguished).
There are vacuum cleaners specifically made to remove ash (even if the ash is warm). Contact your
dealer for details.

Clean the Glass (if necessary)

This appliance has an airwash to keep the glass clean. However, burning un-seasoned wood or burning
on lower burn rates leads to dirtier glass (especially on the sides). Clean the glass by following the
directions below.
For Stubborn Creosote:
Dip newspaper or a paper towel in cool
ashes and wipe it on the glass. The ash
acts as a light abrasive.
Allow the stove to fully cool. Apply glass
cleaner or soapy water to the inside of
the glass. Wipe with newspaper or a
paper towel.
The glass will develop a very slight haze over time. This is normal and will not affect viewing of the fire.