Display Keys Page 24

2420 User Guide Page 24

IP Office 40DHB0002USEG - Issue 1 (29/04/2003)

Longhand Programming
1. Press Admin or Admin 1. See "Display Key Programming" on
page 22. .
2. Pressing Expl? to switch to longhand programming mode.
3. Press Next until the required function required is shown, then press
Selct .
4. If the function requires some data to be entered, [ is shown at the
bottom of the display. Enter the data using the normal telephone
keypad.
5. The upper part of the display reverts to showing the functions currently
assigned to each and key.
6. Use the and keys to move between the pages of display keys.
7. Select the display key against which to program the new function by
pressing that or key.
• Do not select the slot used for the Admin function. Replacing this
function will lock the phone for further programming until reset
through the telephone system.
8. If the display slot is not already used, the display shows BUTTON
PROGRAMMED!. Press the or keys until EXIT is shown.
• Press EXIT to end programming.
• Press Cont to continue programming other functions.
9. If the display slot already has a programmed function, the display shows
FEATURE ON BUTTON. Press the or keys until Repla, Keep
and Delet are shown along the right-hand edge of the display.
• Press Repla to replace that existing function with the one just
programmed. The display then shows BUTTON PROGRAMMED!
as above.
• Press Keep to keep the existing function and forget the function
just programmed.
• Press Delete to delete the existing function and forget the
function just programmed.