Display Keys Page 43 2420 User Guide Page 43 IP Office 40DHB0002USEG - Issue 1 (29/04/2003) NATim - Set No Answer Time
Sets the extension's no answer time after which ringing calls are forwarded
or go to voicemail.
This function requires the time in seconds to be entered when
programmed. The value is shown next to NATim. This function cannot be
programmed through the phone by the user.
Pressing NATim sets the extension's busy wrap up time to the
indicated number of seconds. This time is used to set a delay between
ending one call and the next call ringing the extension (the waiting call may
be indicated on the display however).
[User | Button Programming | Advanced | Set | Set No Answer Time]
See also:
• "WUTim - Set Wrap Up Time" on page 53.
OCSeq - Set Outside Call Sequence
Sets the ringing pattern (sequence) used for internal calls. Not supported
by the 2420.
This function requires the ringing pattern (0 to 9) to be entered when
programmed. The number is shown next to OCSeq. This function cannot
be programmed through the phone by the user.
Pressing OCSeq changes the extension's ringback ringing pattern.
[User | Button Programming | Advanced | Set | Set Outside Call Seq]
See also:
• "ICSeq - Set Inside Call Sequence" on page 41.
• "RBSeq - Set Ringback Sequence" on page 47.
Page - Page
Page the specified target extension or group. The target must be capable of
hands-free speech.
This function requires the target extension or group number to be specified
when programmed. The target is then shown next to Page. This
function cannot be programmed through the phone by the user.
[User | Button Programming | Advanced | Dial | Dial Paging]
See also:
• "GrpPg - Group Paging (!)" on page 37.
Park - Park (#)
Park and unpark calls to and from a specific park slot.
This function requires entry of a park slot number when programmed. That
number and Park then appears next to the key. This function can be
programmed through the phone by the user using an Admin 1 key.
The user can use the key to park calls into that park slot and unpark
calls from that slot.
When a call is parked in that park slot (by any user), a symbol appears
next to the key.
[User | Button Programming | Park]
See also:
• "CPark - Call Park (!)" on page 29.
• "Park - Call Park to Other Extension (!)" on page 44.
• "Ride - Ride Call" on page 49.