Avaya 8400-SES manual Configure IP Network Region, ## SET G726PAYLOADTYPE, SET ENABLEG722

##G.726 Codec Enabled

##Determines whether G.726 codec is available on the

##phone. This parameter is not supported on 16cc phones.

##0 for No

##1 for Yes

##SET ENABLE_G726 1

##

##G.726 Payload Type

##Specifies the RTP payload type to be used with the

##G.726 codec. (96-127). This parameter is not supported

##on 16cc phones.

##SET G726_PAYLOAD_TYPE 110

##

##G.722 Codec Enabled

##Determines whether G.722 codec is available on the

##phone. This parameter is not supported on 16cc phones.

##0 for No

##1 for Yes

##SET ENABLE_G722 0

SET ENABLE_G722 1

##

##DTMF Payload Type

##Specifies the RTP payload type to be used for RFC

##2833 signaling. (96-127).

##SET DTMF_PAYLOAD_TYPE 120

##

##DTMF Transmission Method

##Specifies whether DTMF tones are sent in-band, as

##regular audio, or out-of-band, using RFC 2833

##procedures.

##1 for in-band

##2 for out-of-band using RFC 2833

##SET SEND_DTMF_TYPE 2

##

.

.

.

5.3. Configure IP Network Region

This section describes the steps for administering an IP network region in Communication Manager for communication between Communication Manager and SIP Enablement Services. Enter the change ip-network-region <n> command, where n is a number between 1 and 250 inclusive, and configure the following:

∙Authoritative Domain – Enter the appropriate name for the Authoritative Domain. Set to the appropriate domain. During the compliance test, the authoritative domain is set to avaya.com. This should match the SIP Domain value on SIP Enablement Services, in Section 6.1.

∙Intra-regionIP-IP Direct Audio – Set to yes to allow direct IP-to-IP audio connectivity between endpoints registered to Communication Manager or SIP Enablement Services in the same IP network region. The default value for this field is yes.

∙Codec Set – Set the codec set number as provisioned in Section 5.2.

∙Inter-regionIP-IP Direct Audio – Set to yes to allow direct IP-to-IP audio connectivity between endpoints registered to Communication Manager or SIP Enablement Services in different IP network regions. The default value for this field is yes.

CRK; Reviewed:	Solution & Interoperability Test Lab Application Notes	8 of 21
SPOC 7/1/2011	©2011 Avaya Inc. All Rights Reserved.	Polycom8400-SES