Using your Avaya 1165E IP Deskphone
63
Method A:
1. Press the wall-mount lever, and pull the phone away from the stand,
as shown in Figure 13 on page 63.
2. Use the stand cover (the part you removed in “Removing the stand
cover” on page 57), to mark the wall-mount holes by pressing the
bottom of the stand cover firmly against the wall in the location where
you wish to install the phone. Four small pins on the bottom of the
stand cover make marks on the wall.
3. Use the marks as a guideline for installing the wall-mount screws (not
provided). Install the screws so that they protrude 3 millimeters (mm)
(1/8 inch) from the wall.
4. Install the phone stand mounting holes over the screw heads as
indicated in Figure 12 on page 62 (Method A). You need to remove
the phone from the wall to adjust the lower screws.
5. When the lower screws are snug, install the phone on the mounting
screws, and then tighten the top screws.
Figure 13: Rotate the phone into the wall mount position.
Tilt lever Wall-mount lever