Operation | MAC2000 |
7.If more refrigerant needs to be added, press the Additional Charge function key. Otherwise, press the Done function key to exit the
8.Close the
Important! If the hoses are not removed from the vehicle before the Start key is pressed, the refrigerant in the vehicle will be recovered!
9.If any oil was removed during the recovery or evacuation process, make sure that the proper amount of oil is added back into the vehicle’s A/C high side port in accordance with the vehicle manufacturer’s recommendations. Add an amount of new oil equal to the amount collected in the oil drain bottle (see MAC2000 Left- Side View, Page 5).
3.6System Flush Mode (Oil Flush)
The System Flush mode is designed to be used on General Motors vehicles using their Oil Flush Adapter and Filter accessory. This accessory is attached inline with the vehicle’s compressor and is used to flush the A/C system with refrigerant. In this mode, refrigerant is circulated through both the A/C system and the MAC2000 where an oil separator removes the oil and returns
1.Before beginning the flushing process, recover all refrigerant from the vehicle’s A/C system per Section 3.3 Recovery Mode.
2.From the Main menu, press the Next menu function key to display Menu 2, and then press the System flush function key to select the System Flush mode. The unit reminds the technician to “Please empty the purge oil bottle prior to flushing.”
3.Press Start to continue. The unit now reminds the technician to install the inline flushing adapter and remove the orifice tube or TXV valve before continuing.
4.If not already done, connect the high- and
22 | Instruction |