BAD BOY™ SPOT LUMINAIRE USER MANUAL
20 02.9812.0001C

To connect power and data:

Step 1. Connect data cable (DMX512 or Ethernet) from console to appropriate input connector at

first luminaire in chain (Figure 2-10).

Step 2. If required, connect additional data cables from appropriate thru connectors to input

connectors of remaining luminaires in chain.

Step 3. For DMX512 systems: At last luminaire in chain, install male termination connector at

DMX512 THRU connector. (Luminaires and other devices on the same DMX512 chain may

not function properly without termination.) Refer to "DMX512 Male Termination

Connector" on page 12.

Step 4. At each luminaire, connect AC Line Cord Cable Assembly from power input source.

Step 5. Dress and secure all cables so that they will not interfere with luminaire head or yoke

movement.

* The Ethernet ports are not assigned as either In or Thru as the DMX512 ports are. Ethernet can be

connected in any configuration.

Figure 2-10: Connecting Power and Data Cables

Note: If control data is active on both XLR and Ethernet connections, the fixture will follow the

DMX512 commands coming from the XLR.

200 -2 40 VAC
15A Ma x
50 / 60 Hz
COMM
IN
DMX
THRU
ETHE RNET
ACIN 200 -240 VAC
15AMax
50 / 60 Hz
COMM
IN
DMX
THRU
ETHERNET
ACIN 200 -240 VAC
15A Max
50 / 60 Hz
COMM
IN
DMX
THRU
ETHE RNET
AC IN

DMX512 In Power In Power In Power In

Termination

Connector

DMX512 Daisy-Chain

DMX512 Thru DMX512 Thru

200 -2 40 VAC
15A Ma x
50 / 60 Hz
COMM
IN
DMX
THRU
ETHE RNET
ACIN 200 -240 VAC
15AMax
50 / 60 Hz
COMM
IN
DMX
THRU
ETHERNET
ACIN 200 -240 VAC
15A Max
50 / 60 Hz
COMM
IN
DMX
THRU
ETHE RNET
AC IN

Ethernet

Power In

Ethernet Daisy-Chain *

Power In Power In

Ethernet Ethernet