Bad Boy Mowers 02.9812.0001C user manual Replacing a Designer Color Filter

BAD BOY™ SPOT LUMINAIRE USER MANUAL

Replacing a Designer Color Filter

Parts:

Designer Color Filter(s), as required

Tools and Supplies:

#2 Phillips screwdriver Cotton gloves or finger cots

WARNING: Remove power from luminaire before performing any maintenance procedures.

To replace a designer color filter:

Step	1.	Remove power from
		luminaire.
Step	2.	Locate appropriate head
		cover door for access to

Designer Color Wheel as shown in Figure 4-10on page 73. (Doors are identified by a label.) Turn captive screw to open door.

CAUTION: Do not touch color filters with bare fingers. Wear cotton gloves or finger cots when handling.

Step	3.	Rotate wheel until desired
		designer color filter is
		accessible.
Step	4.	Rotate Color and Gobo 2
		Wheels so that their "open"
		position lines up next to the
		designer color filter you
		wish to replace. (This will
		avoid potential damage to
		the adjacent wheels as the
		filter is being replaced.)
Step	5.	Using fingers, grasp frame
		of color filter and pull out of
		wheel hub (Figure 4-13).

Designer Color Filter

Carrier

3

2

4

1

5 Open Hole (no filter)

Wheel Hub

6 7

Note: Drawing is flipped 180° for clarity purposes.

Step	6. Noting proper orientation of
		Figure 4-13: Replacing a Designer Color Filter
	carrier, insert new designer
	color filter into position and
	push until carrier clicks into place. Refer to Figure 4-14on next page for an overview of
	designer filter positions.
76			02.9812.0001C