Barco DP-1200/DP-1500/DP-2000 R59770175/01 2. XENON BULB LAMP REPLACEMENT PROCESS

1 27

2. X enon bulb lamp replacement process

2. XENON BULB LAMP REPLACEMENT PROCESS

About this chapter

This chapter describes how to replace the xenon bulb lamp in the lamp house. Also included are the procedure to reset the lamp

parameters, which is required aftera x enon bulb lamp replacement, and the procedure to realign the lamp in its reﬂector for optimal

performance.

Overview

• Removal of the lamp house

• Removal of the xenon bulb lamp

• Installation of the xenon bulb lamp

• Installation of the lamp house

• Resetting the lamp parameters

• Realignment of the lamp in its reﬂector

R59770175 XENONBULB LAMP REPLACEMENT 24/09/2008 7

Contents

Main Page Changes Copyright Guarantee and Compensation Trademarks Page Table of contents TABLE OF CONTENTS Page 1. XENON BULB LAMP 1.1 Introduction 1.2 Supported xenon bulb lamps Supported xenon bulb lamps (without lamp house) Page 2. XENON BULB LAMP REPLACEMENT PROCESS 2.1 Removal of the lamp house Page 2.2 Removal of the xenon bulb lamp Page CAUTION:Expired xenon bulblamps. 2.3 Installation of the xenon bulb lamp 2,5 Nm 9 Nm Page 2,5 Nm A CAUTION:TheLAMP INFO parameters which are stored on a chip inside thelamp house MUST be updated 2.4 Installation of the lamp house Page 2.5 Resetting the lamp parameters How to reset the lamp parameters? CAUTION:For more informationabout using the Communicator touch panel consult the users guide of the 2.6 Realignment of the lamp in its reector Page Index INDEX I L R X