Bay Technical Associates 528H, 5218H, 529H, 525H owner manual

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

NOTE: Before you proceed with installation, make certain that the device connected to the host port is setup to have the same configuration as the multiport host port. The H-Series multiports are factory configured as follows:

Serial ports power up from the factory at: 9600 baud rate

8 word size

1 stop bit No parity XON/XOFF disabled

Control character: Control-T(14 Hex).

Terminating character: Carriage Return (0D Hex).

Data block length: 32 characters.

Mode of operation: Mode 1 - Port expansion/sharing.

If the factory default configuration for all ports is not satisfactory for your application, you must reconfigure the multiport by entering the configuration mode (see Section 6). The controlling or host device is connected via cable to the host port on the H-models. This is Port 5 of the 525H, Port 9 of the 528H and 529H, and Port 18 of the 5218H. Peripheral devices are connected via cable to any of the remaining ports. They need not be installed in any specific order. Peripheral ports not used may be left empty.

8