By responding to the Enter Request: message at the end of the main configuration menu (see Section 6.1) with "5" (Set Control Character), you may change the control character.
WARNING: BayTech advises you to log your new control character. If it is forgotten, you will not be able to control the unit or access the configuration mode.
CONTROL
CHARACTER____________ DATE______ BY___
CONTROL
CHARACTER____________ DATE______ BY___
The multiport will respond with:
Current Control Character is | 14H |
Enter Control Character in Hex | : |
You may now enter the new control character that you want in HEX (00 to 7F Hex). For example, if you enter "15 "
Current Control Character | is | 15H |
Save Changes Permanently? | (Y/N): |
|
If you answer "Y" (yes), the new control character will be saved in
Are You Sure? (Y/N):
This message gives you a second chance to consider this change and reminds you to log your new control character. If you answer either question with "N" (no), the new control character will be stored in RAM and lost upon next
