Installation
3.5 Connecting water supply
NOTE
¾¾ The water supply pressure required to run the product is between 1 to 10 bars (0.1 – 1 MPa). It is necessary to have 10 – 80 litres of water flowing from the fully open tap in C one minute to have your machine run smoothly. Attach a pressure reducing valve if water
pressure is higher.
¾¾ If you are going to use the double
CAUTION
¾¾ Models with a single water inlet should not be connected to the hot water A tap. In such a case the laundry will get damaged or the product will switch
to protection mode and will not operate.
¾¾ Do not use old or used water inlet hoses on the new product. It may cause stains on your laundry.
1 | 2 | 3 |
1Connect the special hoses supplied with the product to the water inlets on the product. Red hose (left) (max. 90 ºC) is for hot water inlet, blue hose (right) (max. 25 ºC) is for cold water inlet.
CAUTION
A¾¾ Ensure that the cold and hot water connections are made correctly when installing the product. Otherwise, your laundry will come out hot at the end of the washing process and wear out.
2Tighten all hose nuts by hand. Never use a tool when tightening the nuts.
3Open the taps completely after making the hose connection to check for water leaks at the connection points. If any leaks occur, turn off the tap and remove the nut. Retighten the nut carefully after checking the seal. To prevent possible water leakages, keep the taps closed when the machine is not in use.
User’s Manual | 17 / EN |
|
|
