Troubleshooting, Problem Possible Cause/Solution | Belkin F5D5230-4

Troubleshooting

Problem	Possible Cause/Solution

I cannot access the web-based	1. Accessing the Router setup
Router setup utility when typing	utility can take up to 15
the correct address: 192.168.2.1	seconds. Be sure that you
	wait long enough.

	2. Check the connection
	between the PC and the
	Router making sure that the
	network cable is connected
	to any port labeled LAN.
	3. Check the LAN link light on
	the front of the Router. The
	light that corresponds to the
	port that the computer is
	connected to should be
	illuminated. If it is not, check
	your connection or network
	interface card.
	4. Open the IP configuration
	panel (described earlier in this
	manual). Select your adapter
	and press "Release". After the
	IP address has been released,
	click "Renew". Your computer
	should obtain an IP address
	from the Router.
	5. Reset the Router and begin
	again perform the above
	step again.

39

Image 41

Belkin F5D5230-4 manual Troubleshooting, Problem Possible Cause/Solution

Contents

Port Cable/DSL Gateway Router Table of Contents Introduction Integrated 10/100 4-Port SwitchNAT Firewall Security Built-in Dhcp System Requirements Package ContentsWeb-Based User Interface Product Descriptions Rear Panel WAN Link Status Wall Mounting the Belkin Gateway Router Belkin Docking OptionsBelkin Docking Ring Is my IP address Static or Dynamic? Sharing Your Internet Connection Is Done In 4 Easy Steps Step Does my Internet service provider use PPPoE?Is my connection bound to a MAC address? Does my connection have an assigned host name? My IP Address is User Name Assigned by your ISP Password Service Name Step Write your IP Configuration settings here Connect Your Equipment Basic Parts Required for Each Computer on Your List NIC Step Configuring Your Computers Using Belkin NetSetup Setup your computers for networkingInstalling the Belkin Soho Networking Software Step Step Step Step Step Step Verify That Your Computers are Networked Step Accessing the Web-Based Setup Utility Configuring Your Router if Your Provider Uses Dynamic Step Step Step Step Configuring Your Router if Your Provider Uses PPPoE Step Click MAC Cloning/Entry. The following screen will appear Security Log DMZ SettingsIntrusion Detection On/Off Virtual Server Settings Special Application Settings Client Filter Settings NAT Enable/Disable Services LAN Dhcp Settings Set Time Zone Change PasswordRemote Management Utilities Restore Defaults Reset Update Firmware Problem Possible Cause/Solution Troubleshooting Between the Gateway Router Make sure your computers Make sure the coaxial cable Glossary of Terms Glossary of Terms Port Cable/DSL Gateway Router F5D5230-4 Product Specifications CE Declaration of Conformity Warranty, FCC, CE Statement P73794