Alternate Setup Method
Setting your ISP Connection Type to Static IP (IPoA)
This connection type is also called “Classical IP over ATM” or “CLIP”, which your ISP provides a fixed IP for your Modem Router to connect to the Internet.
(1)
(2) 
(3)
(4)
(5)
1.WAN IP Address - Enter an IP address assigned by your ISP for the Modem Router WAN interface.
2.WAN Subnet Mask - Enter a subnet mask assigned by your ISP.
3.Default Route - Enter a default gateway IP address. If the Modem Router cannot find the destination address within its local network, it will forward the packets to the default gateway assigned by your ISP.
4.VPI/VCI - Enter your Virtual Path Identifier (VPI) and Virtual Circuit Identifier (VCI) parameter here. These identifiers are assigned by your ISP.
5.Encapsulation - Select LLC or VC MUX your ISP uses.
Click “Apply Changes” to save and activate your settings. To go back to the original settings before saving, click “Clear Changes”. Or click any of the
1
2
3
4
5
6
7
8
9
10
section
32
