Shutdown | BenQ CP120C specs

Shutdown

1.Press the Power button and a prompt message appears. Press the Power button a second time to turn the projector off.

2.The POWER indicator light flashes orange

and the lamp shuts down, the fans continue to run for the time duration as determined by the Quick Cooling function (see "Quick Cooling (On)" on page 33) to cool down the projector.

To protect the lamp, the projector will not

respond to any commands during the cooling process.

3. Disconnect the power cord from the wall socket.

•Do not unplug the power cord before the projector shutdown sequence is complete or during the cooling down process.

•If the projector is not properly shut-down, you risk damaging the lamp. Do not move the projector whilst the lamp is hot.

Using the projector

27

Image 33

BenQ CP120C user manual Shutdown, Disconnect the power cord from the wall socket

Contents

Welcome Disclaimer Copyright Table of Contents Iv Table of Contents Fine-tuning the image size and clarity Table of Contents Memo Vi Table of Contents Important safety instructions But could fail if power cuts or surgesImportant safety instructions Safety instructions Following environments Do not place this unit on a blanket Do not block the ventilation holesBedding or any other soft surface Other item Safety instructions Projector features IntroductionIntroduction Shipping contents Front / Upper side Projector exterior viewRear side Lower side Controls and functions External control panelTurns the projector on or off Selects one of the application modes Adjusts the focus of the projected image Freeze button Remote control description Installing or replacing the remote control battery Remote control effective range Choosing a location Positioning your projectorObtaining a preferred projected image size Equipment Select your screen size Positioning your projector Screen size chart Maximum Minimum ZoomScreen Center of lens Projection distance Connecting a computer ConnectionConnection Best video quality Connecting Video source devices Component Video to VGA D-Sub adaptor cable Device Connecting a Component Video source device Video cable Device Connecting an S-Video source device Connecting a composite Video source device Using the projector Using the projectorStart up Utilizing the password function To set a passwordIf you forget the password Adjusting the height To enter the password recall procedureTo change the password Fine-tuning the image size and clarity Auto-adjusting the imageThat you need using the zoom ring Focus ring Correcting keystone Brightest Presentation Default SRGB/Photo Gaming Video Selecting an application modeMovie default Cinema Photo Gaming Using the projector Automatic keystone correction Hiding the image Switching input signalRemote paging operations Freezing the image Shutdown Disconnect the power cord from the wall socket Menu system Menu operation Using the menus Picture menu Keystone Selected Application ModeColor Temp Depends on Pro-Picture menu Setting menu Advance menu Auto Off Off Turned off. Selecting Off disables this functionEconomic Periods of time 10hours without shutdown Mode Equivalent ResolutionInformation Menu Source Care of the projector Maintenance Message Status Calculation of lamp hour Replacing the lamp Resetting the lamp counter Temperature information Projector needs to cool after the power is Turned off IndicatorsStand-by mode Powering up Maintenance Projector does not turn on TroubleshootingNo picture Image is unstable Remote control does not work Projector specifications Specifications Timing chart DimensionsHorizontal Vertical Pixel Resolution Frequency Mode KHz MHz Supported timing for PC input Signal Format Horizontal Frequency Vertical Frequency KHz Supported timing for Component-YPbPrInputSupported timing for Video and S-Video inputs Warranty Limited warrantyWarranty FCC statement Regulation statementsEEC statement Ices Statement Canada Memo Regulation statements