VoIP/(802.11g) ADSL2+ (VPN) Firewall Router
VLAN groups need to be created. Ethernet: P1 (Port 1)
Ethernet1: P2, P3 and P4 (Port 2, 3, 4) Please uncheck P2, P3, P4 from Ethernet VLAN Port first.
Note: You should setup each VLAN group with caution. Each Bridge Interface is arranged in this order.
Bridge Interface | VLAN Port (Always starts with) | ||
Ethernet | P1 | / P2 | / P3 / P4 |
Ethernet1 | P2 | / P3 | / P4 |
Ethernet2 | P3 | / P4 |
|
Ethernet3 | P4 |
|
|
Step 2: Create WAN Interface
Go to Configuration WAN ISP
wanlink is the factory default WAN interface which in service for data/internet access. If your ISP uses this access protocol, click Edit to input other parameters if needed. If your ISP does not use PPPoE, you can change the default WAN connection entry by clicking Change.
From the example, 0/40 is used for data/internet and assumes PPPoE is used; click the Edit to change the VPI/VCI to 0/40.
Click Create to setup up additional WAN interface for video applications. Total of 8 VLAN is support; therefore, only 8 WAN interfaces can be created in the table.
From the example, PVC 0/33 to 0/39 is assigned for video using 1483 Bridged mode. Check RFC 1483 Bridged and click Next to continue the setup.
148
Chapter 4: Configuration
