Binatone XDC1520 manual Clock, Monitoring, To set the time on the clock, To stop the clock

Note: If you do not switch off the handset locator function, then 30 seconds later this function will be switched off automatically.

Clock

To set the time on the clock

1.With the telephone in the standby mode, press the MENU button [3].

2.By pressing the button [5], select the ADDITIONAL FUNCTION menu item, after that press OK [3].

3.By pressing the button [5], select the CLOCK menu item, then press OK [3].

4.	By pressing the		or	button [5], select the ON or OFF menu items.
5.	If you chose ON, move to step 6.
6.	By pressing the		or	button [5], set the correct hour. Then press the
	button [5].
7.	By pressing the		or	button [5], set the correct minutes. If you set the 12-
	hour format, then move to step 6. If you set the 24-hour format, move to step 8.
8.	Press the	button [5].
9.	By pressing the		or	button [5], select ÀÌ or ÐÌ.
10. Press OK [3] to confirm.

To stop the clock

1.To stop the activated clock, press the STOP button [4].

2.You can also delay the activation time by 10 minutes by pressing the LATER button [3].

Note: If the clock becomes activated when you pressed no buttons during 1 minute, then it will automatically become activated again in 10 minutes.

Monitoring

This function allows you to listen to what is going on in the next room. Most often this function is used to keep an eye on babies. To use this function, you need to have two handsets registered at the base unit.

Start of monitoring

Handset 1

1.With the telephone in the standby mode, press the MENU button [3].

29

ENGLISH