To Apply chemicals (BDG3100-B3):
1.Press detergent siphon hose (F, Figure 7A) onto barbed fitting located near high pressure hose connection of pump as shown.
7A
F
2.Fill your detergent tank (L, Figure 7B) with
7B
R
F
L
7C
L
3.Place other end of detergent siphon hose (F) with filter (R) on it into detergent tank (L). Make sure filter (R) is fully submerged into cleaning solution.
NOTE: For every 7 gallons of water pumped 1 gallon of chemical/ cleaning solution will be used.
4.Install low pressure (black) nozzle into quick connect fitting of spray wand, see How To Use Spray Wand paragraph in this section.
5.After use of chemicals, refill your detergent tank with clean water and operate your chemical injection system to rinse it thoroughly. If chemicals remain in the pump it could be damaged. Pumps
damaged due to chemicals will not be covered under warranty..
NOTE: Chemicals and soaps will not siphon if the black soap nozzle is not installed on the spray wand
STARTING (FIG. 8–11)
WARNING: To reduce the risk of injury, read the pressure washer instruction manual and the engine instruction manual before starting pressure washer.
DANGER: Risk of fluid injection and laceration. When using the high- pressure setting, DO NOT allow the
•Your washer operates at fluid pres- sures and velocities high enough to penetrate human and animal flesh, which could result in amputation or other serious injury. Leaks caused by loose fittings or worn or dam- aged hoses can result in injection injuries. DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a physician immediately!
WARNING: Risk of Fire, Asphyxiation and Burn. Never fill fuel tank when engine is running or hot. Do not smoke when filling fuel tank.
•Never fill fuel tank completely. Fill tank to 1/2" )12.7 mm) below bot- tom of filler neck to provide space for fuel expansion. Wipe any fuel spillage from engine and equip- ment before starting engine.
•Never run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust contains carbon monoxide, an odorless and deadly gas.
•DO NOT let hoses come in con- tact with very hot engine muffler during or immediately after use of your pressure washer. Damage to hoses from contact with hot engine surfaces will NOT be covered by warranty.
36- ENG
