TROUBLE SHOOTING GUIDE

OPERATIONAL

POSSIBLE CAUSE

SOLUTION

ISSUE

 

 

Engine will not

No fuel.

Add Fuel.

start (see Engine

Pressure builds up after

Squeeze gun trigger to relieve

Manual for

two pulls on the recoil

pressure­.

further engine

starter or after initial use.

 

troubleshooting)

Choke lever in the "No

Move choke to the "Choke"

 

Choke" position.

posi­tion­.

 

Spark plug wire not attached.

Attach spark plug wire.

 

Engine switch in OFF

Place engine switch

 

posi­tion­.

in ON position.

 

Choke lever in the "Choke"

Move choke to the "No Choke"

 

position on a "hot" engine

posi­tion­.

 

or an engine that has been

 

 

exposed to thermal heat

 

 

for a long period of time.

 

No or low

Spray wand not in

See How to Use Spray

pressure

high pressure.

Wand instructions in the

(initial use)

 

Operation Section.

Low water supply.

Water supply must be at

 

 

 

least 5 gpm @ 20 psi.

 

Leak at high pressure

Repair leak. Apply sealant tape

 

hose fitting.

if necessary.

 

Nozzle obstructed.

See Nozzle Cleaning

 

 

instructions in the

 

 

Maintenance section.

 

Water filter screen clogged.

Remove and clean filter.

 

Air in hose.

Turn off the engine, then the

 

 

water source. Disconnect the

 

 

water source from the pump

 

 

inlet and turn the water source

 

 

on to remove all air from the

 

 

hose. When there is a steady

 

 

stream of water present, turn

 

 

water source off. Re-­connect­

 

 

water source to pump inlet and

 

 

turn on water­ source. Squeeze

 

 

trigger to remove­ remain­ing­ air

 

Choke in the “Choke”

Move choke to the “No Choke”

 

position.

posi­tion­.

 

High pressure hose

Use high pressure hose under

 

is too long.

100 feet (30 m).

42- ENG­

Page 42
Image 42
Black & Decker BDG2600-B3 Trouble Shooting Guide, Operational Possible Cause Solution Issue, See How to Use Spray