Black & Decker BDG3100-B3 Assembly Instructions, Operation, Basic Elements of AN Engine

J.Pump Inlet

K.Quick Connect Nozzles

L.On Board Detergent Tank (BDG3100-B3): Feeds cleaning agents into the pump to mix with the water. See How To Apply

Chemicals/Cleaning Solvents instructions in Operation section.

BASIC ELEMENTS OF AN ENGINE

Refer to the engine manual for location and operation of engine controls.

Choke Control: Opens and closes carburetor choke valve.

Starter Grip: Pulling starter grip operates recoil starter to crank engine.

Engine Switch: Enables and disables ignition system.

ASSEMBLY INSTRUCTIONS

(FIG. 1– 4)

1.Locate and remove all loose parts from the carton.

2.Cut four corners of the carton from top to bottom and lay the panels flat.

3.Place handle (G) onto frame (H), depress the snap buttons, and slide the handle assembly onto the frame until snap buttons snap into place.

2

G

H

NOTICE: Risk of personal injury. Avoid placing hands between handle and frame when assembling to prevent pinching.

4.Remove the colored quick-connect nozzles (K) from the plastic bag and insert them into correct grommet on the nozzle holder. Nozzles are color coded to match colored nozzles on label (Q).

2A K

Q

5.	Connect wand (E) to gun (D).
	Tighten securely.
3	E	D
6.	Attach high pressure hose (C) to
	gun (D). Tighten secure­ly­.

4 D

C

NOTE: The pump on this unit is maintenance free and requires no oil. If there is a problem with the pump, contact our Customer Service Group on www.BlackandDecker-la.comas soon as possible.

NOTICE: The engine is shipped without oil. Before starting engine, add the oil provided. Damage to the engine will occur if the engine is run without oil, this damage will not be covered under warranty.

OPERATION

PRESSURE WASHER

TERMINOLOGY

PSI: Pounds per Square Inch. The unit of measure for water pressure. Also used for air pressure, hydraulic pressure, etc. Sometimes noted as “Bar”, another unit of measure.

GPM: Gallons per Minute. The unit of measure for the flow rate of water.

CU: Cleaning Units. GPM multiplied by psi equals CU.

Bypass Mode: Allows water to re-circulate within the pump when the gun trigger is not pulled. This feature allows the operator to release the

33-­ ENG