pulsate. Clean the nozzle immediately using the nozzle kit supplied and the following instructions:
1.Shut off the pressure washer and turn off the water supply.
2.Pull trigger on gun handle to relieve any water pressure.
3.Disconnect the spray wand from the gun.
4.Remove the
(K)from the spray wand. Remove any obstructions with the nozzle cleaning tool provided and backflush with clean water.
12 | K |
| |
N | K |
|
5.Direct water supply (N) into spray wand to backflush loosened particles for 30 seconds.
6.Reassemble the nozzle to the wand.
7.Reconnect spray wand to gun and turn on water supply.
8.Start pressure washer and place spray wand into high pressure setting to test.
CLEAN THE WATER INLET FILTER (FIG. 8)
This screen filter should be checked periodically and cleaned if necessary.
1.Remove filter by grasping end and removing it from water inlet of pump.
2.Clean filter by flushing it with water on both sides.
3.
NOTE: Do not operate the pressure washer without filter properly installed.
STORAGE
ENGINE
Consult the Engine Owners Manual for manufacturer’s recommendations for storage.
PUMP (FIG. 13)
NOTICE: The manufacturer recom- mends using a pump protector/win- terizer when storing the unit for more than 30 days and/or when freezing temperatures are expected. FREEZE
DAMAGE IS NOT COVERED BY THE WARRANTY.
Pump protector/winterizer is usually available at the store where the pressure washer was purchased. If a pump protector/winterizer is not available, RV antifreeze needs to be run through the pump as outlined in the steps below.
NOTE: Using a pump protector/ winterizer or RV antifreeze is to provide proper lubrication to the internal seals of the pump regardless of temperature or environment.
1.Obtain a funnel, 6 ounces (170 mL) of RV Antifreeze, and a 16" to 36"
attached to one end.
13
NOTICE: Risk of Property Damage. Use only RV Antifreeze. Any other antifreeze is corrosive and can damage the pump.
2.Disconnect the spark plug wire.
3.Connect the length of garden hose to the water inlet of the pump.
