NOTICE: Risk of property damage. Never pull water supply hose to move pressure washer. This could damage hose and/or pump inlet.
•DO NOT use hot water, use cold water only.
•Never turn water supply off while pressure washer engine is running or damage to pump will result.
•DO NOT stop spraying water for more than two minutes at a time. Pump operates in bypass mode
when spray gun trigger is not pressed. If pump is left in bypass mode for more than two minutes internal components of the pump can be damaged.
If you do not understand these precautions, please contact our customer service department at
Prior to starting, refer to your engine manual for proper starting procedure.
1.In a well ventilated outdoor area add fresh, high quality, unleaded gasoline with a pump octane rating of 86 or higher. Do not overfill. Wipe up spilled fuel before starting the engine. Refer to Engine Owners Manual for correct procedure.
2.Check engine oil level. See Engine Owners Manual for correct procedure.
3.Connect the water hose to the water source. Turn the water source on to remove all air from the hose. When a steady stream of water is present, turn the water source off.
4.Verify the filter screen (M) is in water inlet of pump.
NOTE: Cone side faces out.
8 |
M |
5.Connect high pressure hose (C) to pump outlet (I).
9
CI
6.Connect water source (N) to pump inlet (J). NOTE: Water source must provide a minimum of 5 gallons per minute at 20 psi.
10
N J
WARNING: To reduce the possibility of contamination always protect against backflow when connected to a potable water system.
7.Choose the correct nozzle for the job to be performed. See How To Use spray Wand instructions in this section. NOTE: If applying a chemical or cleaning solution, see How To Apply Chemicals/ Cleaning Solvents instructions in this section.
8.Turn water source on.
NOTICE: Risk of property damage. Failure to do so could cause damage to the pump.
9.Remove all air from the pump and high pressure hose by depressing trigger until a steady stream of water is present.
10.Start engine. See Engine Owners Manual for correct procedure.
