Chapter 3: Hardware Installation
3. Hardware Installation
3.1 Power Cord Requirements
Power cords must meet the requirements for the country where you will use the PoE Injector.
U.S. and Canada
•The cord must have a minimum of
•The cord must be UL® or CSA approved.
•The minimum requirement for the flexible cord is:
-18 AWG
-
-Type SV (stranded vacuum rubber jacketed) or SJ (stranded junior rubber jacketed) or SVT (stranded vacuum rubber jacketed thermoplastic) or SJT (stranded junior thermoplastic)
•The plus must be
Europe
Switzerland
• The supply plug must comply with SEV/ASE 1011.
Denmark
• The supply plug must comply with section
United Kingdom
•The PoE Gigabit Injector is covered by General Approval (section 16.16.060, NS/G/12345/J100003, for indirect connection to a public telecommunication system.
France and Peru
•IT equipment cannot power this device. In the case of an
•The PoE Gigabit Injector must have access to a nearby power outlet. By disconnecting the power cord from the outlet, you will eliminate power from the device.
•The flexible cord that connects to the PoE Gigabit Injector must have a configuration to connect with an EN60320/IEC320 inlet connector.
•According to the EN60950/IEC 950 specifications, this device functions under SELV (Safety Extra Low Voltage) conditions. The conditions are true if the equipment and the connected device functions under SELV conditions.
Page 11 |