![](/images/new-backgrounds/1158524/158524221x1.webp)
SERVSWITCH™ AND SERVSWITCH ULTRA™
F.2 The Installation Procedure
CAUTION!
Installing the
If you do install the
Also, you will be removing many screws during the course of the installation. These screws are different lengths and sizes, so note carefully which type of screw goes in which screwhole.
To install the
1.Make sure the Switch is turned OFF, unplugged, and disconnected from all other devices.
2.Unscrew and remove the six screws (four on top and one on each side) that fasten the wraparound
3.Remove the Switch’s top cover.
4.Unscrew and remove the three countersunk screws on the bottom panel that fasten the back panel to the bottom panel. See Figure
5.Unscrew and remove the three countersunk screws on the Switch’s bottom panel that fasten the Switch’s PCB(s) (printed circuit board[s]) to the panel. See Figure
6.Separate the Switch’s PCB(s) and back panel from the bottom panel, being very careful not to bend the LEDs.
7.Depending on how many Expansion Boards you are installing, you will need to remove two or more of the