8-/16-/24-Port 10/100 PoE PSE Web Smart Switch
Case 3: The same VLAN members can be at different switches with the same VID (See Figure
VLAN 1
VLAN 2
VLAN 3
Figure 3-6. Attribute-based VLAN diagram.
3.6 Set IP Address, Subnet Mask, and Default Gateway IP Address
First, either configure your PC IP address or change IP address of the switch. Next, change the IP address of default gateway and subnet mask.
For example, your network address is 10.1.1.0, and subnet mask is 255.255.255.0. You can change the switch’s default IP address 192.168.2.1 to 10.1.1.1 and set the subnet mask to 255.255.255.0. Then, choose your default gateway, for example, 10.1.1.254.
|
| Default Value |
|
| LPB708A/LPB716A |
|
|
| Your Network Setting |
|
|
|
|
|
|
|
|
|
|
|
|
|
| IP Address |
| 192.168.2.1 |
|
| 10.1.1.1 |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
| Subnet |
| 255.255.255.0 |
|
| 255.255.255.0 |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
| Default Gateway |
| 192.168.2.254 |
|
| 10.1.1.254 |
| ||
|
|
|
|
|
|
|
|
|
|
|
After completing these settings in the switch, it will reboot so the configuration will take effect. After this step, you can operate the management through the network.
NOTE: There are no default DNS settings. DNS addresses are assigned by the network administrator.
Before you communicate with the switch, finish the configuration of the IP address or know the IP address of the switch.
Then, follow the procedures listed next.
1. Set up a physical path between the switch and a PC by a qualified UTP CAT5 cable with an
16 |
