Black Box LRA2900A manual Cable installation, Installing the power cables

Model LRA2900A RAS Getting Started Guide 2 • Hardware installation

5.Secure the RAS in position with the mounting screws.

Cable installation

This section describes installing the power, ground, and network interface cables.

Installing the power cables

This section describes installing the female end of the power cables into the IEC-320 connectors on the RAS. Do not connect the male end of the power cables to the power outlet at this time. Do the following:

1.Install a power cable into an IEC-320 connector (see figure 5).

Power cable retainer clip

	-	264V
		Hz)
90
(50	-60
	AMP
2

ETHERNET

Grounding stud

IEC-320 connector

(2 places)

Figure 5. IEC-320 connector and grounding stud locations

To avoid the risk of injury from electric shock, the power cords connected to the IEC-320 connectors must be grounded power cords.

2.Rotate the power cable retainer clip so it secures the power cable plug in the IEC-320 connector as shown in figure 6.

ETHERNET

Grounding stud

Power cable retainer clip

	-	264V
		Hz)
90
(50	-60
	AMP
2

Figure 6. Power cable retainer clip

Cable installation 24