Model LRA2900A RAS Getting Started Guide | 3 • Configuring the RAS for operation |
|
|
Configuring line settings and signaling for T1
1.Select T1/E1 Link on the Configuration Menu. The T1/E1 Link Activity window appears (see figure 27 on page 42).
2.Link: 1 corresponds to Line 1 on the RAS. This is the primary link for
Configuring the line settings
1.Click on the Line Type
–dsx1ESF Extended SuperFrame DS1
–dsx1D4 AT&T D4 format DS1
–For ISDN PRI service, set the line type to dsx1ESF
2.Click on the Line Coding
3.Click on the Line Build Out
4.Click on the Yellow Alarm Format
5.Click on Submit Query.
At this point, the WAN front panel LEDs will become active. A solid green FRAME light indicator means that the RAS has synchronized with the T1 line.
If you have an T1/PRI (ISDN) line, refer to “Setting the line signaling for an ISDN/PRI line”. Otherwise, refer to “Setting the line signaling for a
Setting the line signaling for an ISDN/PRI line
Do the following:
1.Scroll down the WAN Circuit Configuration window, until the signaling Settings section appears (see figure 29 on page 43).
2.Click on the Signal Mode
3.Click on the Message Oriented Switch Type
4.Click on Submit Query.
Signaling is now configured for ISDN/PRI.
Setting the line signaling for a
Do the following:
1.Scroll down the WAN Circuit Configuration window, until the signaling Settings section appears (see figure 29 on page 43).
2.Click on the Signal Mode
3.Click on Submit Query.
Configuring the RAS with a Web browser | 46 |