Chapter 3: Installation
3.When the unit is connected, the LEDs will enter the
4.Plug a sensor into one of the dry contact ports on the rear panel of the unit. In this example, we will use Port 1.
Figure 3-12. Plug sensor into Port 1.
5.After the unit is connected, access your Web interface, type the desired IP address into your browser and log in, and navigate to the summary page. Two boards will be displayed within the sensor information window as shown in Figure
Figure 3-13. Sensor information window.
6. Click on the lower of the two boards and the sensors page will appear.
NOTE: You can also access this page by clicking on the “Sensors” tab at the top of the summary page.
Page 15 |
