DSC programming
DSC (Direct Software Control) allows you to customise certain programmable, basic settings to suit your personal needs and preferences and then store them.
The basic settings for this audio equipment were made at the factory.
In the following you can find an overview of these settings, so that you can always reset to these if desired.
If you wish to alter any of the programming,
•press SRC to select one of the operat- ing modes radio or cassette (e.g. ra- dio, if you wish to change the language with PTY LANG).
•press DSC.
Use the rocker switch to select and adjust the functions described in the following. The display will show you the adjusted condition.
/
Select function
<<>> Adjust/recall value
AM ON / OFF (Montreux RCR 127)
You can deactivate one or both AM bands (MW/LW) in order to reduce the number of bands for selection with BND.
selectable:
AM ON – all bands
MW OFF – LW, FM
LW OFF – MW, FM
AM OFF – FM
RM ON / OFF (Radio Monitor)
Allows you to listen to the radio during fast winding of the tape.
RM ON – Radio playback activated
RM OFF – Function deacti- vated
LOUDNESS When listening at a low lev- el, the Loudness function creates a more natural sound by boosting the low frequency range.
LOUD 1 - Low boost LOUD 6 - Max. boost
TA VOL To adjust the traffic an- nouncement and beep tone volume from between 0 to 63.
The message will then come through at this volume, if the volume adjusted for the pro- gram is lower.
If the program volume is higher than the TA VOL lev- el, the traffic report will be played slightly louder.
BEEP Acknowledgement tone for all functions which require a button to be pressed for more than 1 second.
The volume can be adjusted from between 0 to 9. (0 = off)
LED ON/OFF You can choose between LED ON or LED OFF. With LED ON, the KeyCard tongue will flash for extra
40
