![](/images/new-backgrounds/1289338/28933823x1.webp)
If you leave the service area of the regional | Station tuning | |
programme tuned into, or if you would like | Automatic tuning / | |
to take advantage of the full RDS service, | ||
• Press / ; the car radio will automati- | ||
switch to “REG OFF”. | ||
• Press the AF button for approximately | cally search for the next station. | |
1 sec. until “REG OFF” appears. | When keeping the upper or lower part / |
If the REG function is active, “REG ON” will of the rocker switch depressed, seek tuning | ||
be briefly displayed each time the radio is | will speed up in upwards or downwards di- | |
rection. | ||
switched on. | ||
|
Manual tuning:
•Press << >>; the frequency will change in short intervals in downwards or up- wards direction.
When holding the right or left part of the rock- er switch depressed, the frequency scan is speeded up.
Scrolling through the broadcast- ing networks (FM only)
Selecting a waveband
(only Montreux RCR 127)
You can select between the following wave- bands:
FM 87.5 - 108 MHz
MW 531 - 1602 kHz
LW 153 - 279 kHz
•Press the BND button until the desired waveband shows on the display panel.
Note:
In the DSC menu you can deactivate the station selection on either MW or LW or for both wavebands at the same time.
This has the advantage that only the re- quired bands will allow to be activated, so that you must press the BND button less often. For more information, please refer to chapter “DSC programming - AM ON/OFF”.
Seek tuning
Up
Down
<</ >> Up/Down in short intervals
(FM only, “AF” must be switched off)
Manual tuning with << >>
You can also tune in a station manually.
Condition:
AF and PTY must be switched off (i.e. the symbols do not light up in the display).
If necessary, deactivate these functions:
•Press AF or PTY briefly.
You can use the << >> buttons to tune in stations of your reception area.
If several programmes of the broadcasting networks can be received, you can scroll through them in forwards direction pressing >>, or backwards using the << button, e.g. NDR 1, 2, 3, 4,
For this it is necessary that the stations have been tuned in at least once and that “AF” is active (lights up in the display).
For this purpose, start automatic tuning, e.g. using Travelstore:
•Press FMT or BND for 1 sec.; the system starts to run through the fre- quency band. The display shows
If “AF” does not light up,
•press AF.
This fulfils the requirements for selecting stations with << >>.
32