298Configuring RF Auto-Tuning

Changing Power Tuning Settings

Enabling Power Tuning

RF Auto-Tuning for power is disabled by default. To enable or disable the feature for all radios in a radio profile, use the following command:

set radio-profile name auto-tune power-config {enable disable}

To enable power tuning for radios in the rp2 radio profile, type the following command:

23x0# set radio-profile rp2 auto-tune power-config enable

success: change accepted.

Changing the Power Tuning Interval

The default power tuning interval is 300 seconds. You can change the interval to a value from 1 to 65535 seconds. To change the power tuning interval, use the following command:

set radio-profile name auto-tune power-interval seconds

To set the power tuning interval for radios in radio profile rp2 to 240 seconds, type the following command:

23x0# set radio-profile rp2 auto-tune power-interval 240

success: change accepted.

Changing the Power Backoff Interval

The default power backoff interval is 10 seconds. You can change the interval to a value from 0 to 65535 seconds. To change the power backoff interval, use the following command:

set radio-profile name auto-tune power-backoff-timer seconds

To change the power-backoff interval for radios in radio profile rp2 to 15 seconds, type the following command:

23x0# set radio-profile rp2 auto-tune power-backoff-timer 15

success: change accepted.

Changing the Maximum Default Power Allowed On a Radio

By default, the maximum default power level that RF Auto-Tuning can set on a radio is the same as the maximum power level allowed for the country of operation. To change the maximum default power level that RF Auto-Tuning can assign, use the following command:

set {ap port-listdap dap-num}radio {1 2} auto-tune max-power power-level

The power-levelcan be a value from 1 to 20.

320657-A

Page 298
Image 298
Nortel Networks 2300 manual Changing Power Tuning Settings, Enabling Power Tuning, Changing the Power Tuning Interval