Appendix D: DHCP Server 609

clear interface vlan-idip

Note. This command clears all IP configuration information from the interface.

Displaying DHCP Server Information

To display information about the WSS Software DHCP server, use the following command:

show dhcp-server [interface vlan-id] [verbose]

If you enter the command without the interface or verbose option, the command displays a table of all the IP addresses leased by the server. You can use the interface option to display addresses leased by a specific VLAN.

If you use the verbose option, configuration and status information is displayed instead.

The following command displays the addresses leased by the DHCP server:

23x0# show dhcp-server

VLAN

Name

Address

MAC

Lease Remaining (sec)

----

--------------

---------------

-----------------

--------------------

1

default

10.10.20.2

00:01:02:03:04:05

12345

1

default

10.10.20.3

00:01:03:04:06:07

2103

2

red-vlan

192.168.1.5

00:01:03:04:06:08

102

2

red-vlan

192.168.1.7

00:01:03:04:06:09

16789

The following command displays configuration and status information for each VLAN on which the DHCP server is configured:

23x0# show dhcp-server

 

 

 

Interface:

0

(Direct AP)

Status:

 

 

UP

 

Address

Range:

 

10.0.0.1-10.0.0.253

Interface:

 

 

default(1)

Status:

 

 

 

UP

Address

Range:

 

 

10.10.20.2-10.10.20.254

DHCP Clients:

 

 

 

Hardware Address:

00:01:02:03:04:05

State:

 

 

 

BOUND

Lease

Allocation:

43200 seconds

Lease

Remaining:

 

12345 seconds

IP Address:

 

 

10.10.20.2

Subnet Mask:

 

 

255.255.255.0

Default Gateway:

 

10.10.20.1

DNS Servers:

 

 

10.10.20.4 10.10.20.5

DNS Domain Name:

 

mycorp.com

Nortel WLAN Security Switch 2300 Series Configuration Guide

Page 609
Image 609
Nortel Networks 2300 manual Displaying Dhcp Server Information, Show dhcp-server interface vlan-id verbose