Nortel Networks 2300 manual Displaying a List of Distributed APs, 23x0 # show dap global

Configuring AP access points 283

Displaying a List of Distributed APs

To display a list of the Distributed APs configured on WSS switches in the Mobility Domain, use the following command:

show dap global [dap-numserial-id serial-ID]

This command lists the System IP addresses of all the WSS switches on which each Distributed AP is configured, and lists the bias for the AP on each switch. For each Distributed AP that is configured on the switch on which you use the command, the connection number is also listed.

To display information for all Distributed APs configured on all WSS switches in the Mobility Domain, type the following command:

23x0# show dap global
Total number of		entries: 8
DAP	Serial Id	WSS IP Address	Bias
---	-----------	---------------	----
1	11223344	10.3.8.111	HIGH
-	11223344	10.4.3.2	LOW
2	332211	10.3.8.111	LOW
-	332211	10.4.3.2	HIGH
17	0322100185	10.3.8.111	HIGH
-	0322100185	10.4.3.2	LOW
18	0321500120	10.3.8.111	LOW
-	0321500120	10.4.3.2	HIGH

This command indicates that the Mobility Domain contains four Distributed APs, with serial IDs 11223344, 332211, 0322100185, and 0321500120. Each AP is configured on two WSS switches, with system IP addresses 10.3.8.111 and

10.4.3.2.The bias for the AP on each WSS switch is listed. Normally, a Distributed AP boots from the WSS switch with the high bias for the AP. (For more information, see “Resiliency and Dual-Homing Options for APs” on page 227 and “AP Boot Process” on page 231.)

The DAP field indicates the connection number of each AP on the WSS switch on which the command is typed. A hyphen ( - ) in the DAP field indicates that the AP is configured on another WSS switch in the same Mobility Domain.

Nortel WLAN Security Switch 2300 Series Configuration Guide