Nortel Networks 2300 manual Displaying RF Detection Information

Rogue Detection and Countermeasures 561

Displaying RF Detection Information

You can use the CLI commands listed in Table 35 to display rogue detection information.

Table 35: Rogue Detection Show Commands

Command	Description
show rfdetect clients	Displays all wireless clients detected on the air.
[mac mac-addr]
show rfdetect counters	Displays statistics for rogue and Intrusion
	Detection System (IDS) activity detected by the
	APs managed by an WSS switch.
show rfdetect mobility-domain	Displays information about rogues detected in a
[ssid ssid-name bssid mac-addr]	Mobility Domain.
	This command is valid only on the Mobility
	Domain’s seed switch.
show rfdetect data	Displays information about all BSSIDs detected
	on the air, and labels those that are from rogues
	or interfering devices.
	This command is valid on any switch in the
	Mobility Domain.
show rfdetect visible mac-addr	Displays the BSSIDs detected by a specific
show rfdetect visible	Nortel radio.
ap AP-num[radio {1 2}]
show rfdetect visible
dap dap-num[radio {1 2}]
show rfdetect countermeasures	Displays the current status of countermeasures
	against rogues in the Mobility Domain.
	This command is valid only on the Mobility
	Domain seed.
show rfdetect vendor-list	Displays the list of OUIs that are allowed on the
	network. An OUI identifies a piece of
	networking equipment’s vendor. (See
	“Configuring a Permitted Vendor List” on
	page 544.)
show rfdetect ssid-list	Displays the list of SSIDs that are allowed on
	the network. (See “Configuring a Permitted
	SSID List” on page 545.)
show rfdetect black-list	Displays the list of wireless clients that are both
	allowed on the network. (See “Configuring a
	Client Black List” on page 546.)

Nortel WLAN Security Switch 2300 Series Configuration Guide