Nortel Networks 2300 manual Wildcard Masks, Class of Service, Class-of-Service CoS Packet Handling

		Configuring and Managing Security ACLs 355
Table 22: Common IP Protocol Numbers
	Number	IP Protocol
17		User Datagram Protocol (UDP)
46		Resource Reservation Protocol (RSVP)
47		Generic Routing Encapsulation (GRE) protocol
50		Encapsulation Security Payload for IPSec (IPSec-ESP)
51		Authentication Header for IPSec (IPSec-AH)
55		IP Mobility (Mobile IP)
88		Enhanced Interior Gateway Routing Protocol (EIGRP)
89		Open Shortest Path First (OSPF) protocol
103		Protocol Independent Multicast (PIM) protocol
112		Virtual Router Redundancy Protocol (VRRP)
115		Layer Two Tunneling Protocol (L2TP)

Wildcard Masks

When you specify source and destination IP addresses in an ACE, you must also include a mask for each in the form source-ip-addr mask and destination-ip-addr mask.

The mask is a wildcard mask. The security ACL checks the bits in IP addresses that correspond to any 0s (zeros) in the mask, but does not check the bits that correspond to 1s (ones) in the mask. Specify the IP address and wildcard mask in dotted decimal notation. For example, the IP address and wildcard mask 10.0.0.0 and 0.255.255.255 match all IP addresses that begin with 10 in the first octet.

Class of Service

Class-of-service (CoS) assignment determines the priority treatment of packets transmitted by an WSS switch, corre- sponding to a forwarding queue on the AP. Table 23 shows the results of CoS priorities you assign in security ACLs.

Table 23: Class-of-Service (CoS) Packet Handling

WMM Priority	CLI CoS Value to
Desired	Enter
Background	1 or 2
Best effort	0 or 3
Video	4 or 5
Voice	6 or 7

Nortel WLAN Security Switch 2300 Series Configuration Guide