Nortel Networks 2300 manual Configuring and Managing VLANs, Removing a Port Group

88Configuring and Managing Ports and VLANs

To verify the configuration change, type the following command:

23x0# show vlan config	Admin VLAN Tunl	Port
VLAN Name	Status State Affin Port	Tag State

--------------------------------------------------------------

1 default	Up	Up	5
			server2	none Up

To indicate that the ports are configured as a port group, the show vlan config output lists the port group name instead of the individual port numbers.

Removing a Port Group

To remove a port group, use the following command:

clear port-group name name

Displaying Port Group Information

To display port group information, use the following command:

show port-group [all name group-name]

To display the configuration and status of port group server2, type the following command:

23x0# show port-group name server2 Port group: server2 is up

Ports: 15, 17

Interoperating with Cisco Systems EtherChannel

Load-sharing port groups are interoperable with Cisco Systems EtherChannel capabilities. To configure a Cisco Catalyst switch to interoperate with a Nortel WSS, use the following command on the Catalyst switch:

set port channel port-listmode on

Configuring and Managing VLANs

Note. The CLI commands in this chapter configure VLANs on WSS network ports. The commands do not configure VLAN membership for wireless or wired authentication users. To assign a user to a VLAN, configure the RADIUS Tunnel-Private-Group-ID attribute or the VLAN-Name vendor specific attribute (VSA) for that user. (For more information, see “Configuring AAA for Network Users,” on page 401.)

320657-A