Nortel Networks 2300 manual Displaying Port Statistics, Clearing Statistics Counters

Configuring and Managing Ports and VLANs 85

23x0# show port poe 7,9	Link	Port	PoE	PoE
Port Name	Status	Type	config	Draw

===============================================================================

7	7	down	AP	disabled	off
9	9	up	AP	enabled	1.44

In this example, PoE is disabled on port 7 and enabled on port 9. The AP access point connected to port 9 is drawing 1.44 W of power from the WSS.

(For more information about the fields in the output, see the Nortel WLAN Security Switch 2300 Software Command Reference.)

Displaying Port Statistics

To display port statistics, use the following command:

show port counters [octets packets receive-errors transmit-errors collisions receive-etherstats transmit-etherstats] [port port-list]

You can specify one statistic type with the command. For example, to display octet statistics for port 3, type the following command:

23x0# show port counters octets port 3

Port StatusRx OctetsTx Octets

===============================================================================

3 Up 27965420 34886544

(For information about the fields in the output, see the Nortel WLAN Security Switch 2300 Software Command Reference.)

Note. To display all types of statistics with the same command, use the monitor port counters command. (See “Monitoring Port Statistics” on page 85.)

Clearing Statistics Counters

To clear all port statistics counters, use the following command:

clear port counters

The counters begin incrementing again, starting from 0.

Monitoring Port Statistics

You can display port statistics in a format that continually updates the counters. When you enable monitoring of port statistics, WSS Software clears the CLI session window and displays the statistics at the top of the window. WSS Software refreshes the statistics every 5 seconds. This interval cannot be configured.

Nortel WLAN Security Switch 2300 Series Configuration Guide