Nortel Networks 2300 manual Setting a Port for a Directly Connected AP access port

74Configuring and Managing Ports and VLANs

Flash: 4.0.0.172 - md0a

Kernel: 3.0.0#253: Mon May 9 17:44:47 PDT 2005

BootLoader: 4.1/4.0.8

2Contact Nortel using the email address to the left.

3In the email, please include the coupon code (shown to the left) and serial number. Provide in the body of the email the contact information, including organization or company name, contact name, phone number, mailing address and e-mail address.

4Nortel will verify the validity of the coupon code, and reply to your email with the authorization key unique for the serial number of the switch provided. Nortel will record the license activation key and associated serial number. A record of the serial number and activation key will be kept at Nortel for future reference.

5This certificate should be stored in a secure place for future reference.

When the proper License Activation Key has been obtained, follow the instructions below to enable the WLAN WSS 2380 features:

1Use the following command at the enable (configuration) level of the CLI to install the activation key: set license activation-key

2Type in the entire activation key and press enter

In the following example, an activation key for additional AP’s is installed: 2380# set license 3B02-D821-6C19-CE8B-F20E

success: license accepted

3Verify installation of the new license by typing the following command: show license Support for the additional AP’s begins immediately. The switch does not need to be restarted for the upgrade to be effective.

Setting a Port for a Directly Connected AP access port

Note. Before configuring a port as an AP access port, you must use the set system countrycode command to set the IEEE 802.11 country-specific regulations on the WSS switch. (See “Specifying the Country of Operation” on page 248.)

To set a port for an AP access port, use the following command:

set port type ap port-list

model {AP2750 AP-52 AP-101 AP-122 AP-241 AP-252 AP-262 AP-341 AP-352 AP-2330}

poe {enable disable}

[radiotype {11a 11b11g}]

You must specify a port list of one or more port numbers, the AP model number, and the PoE state. (For details about port lists, see “Port Lists” on page 41.)

320657-A