Nortel Networks 2300 Managing Configuration Files, Removing a Subdirectory, 23x0# rmdir corp2

526Managing System Files

Removing a Subdirectory

To remove a subdirectory from nonvolatile storage, use the following command:

rmdir [subdirname]

To remove subdirectory corp2, type the following example:

23x0# rmdir corp2

success: change accepted.

Managing Configuration Files

A configuration file contains CLI commands that set up the WSS switch. The switch loads a designated configuration file immediately after loading the system software when the software is rebooted. You also can load a configuration file while the switch is running to change the switch’s configuration.

When you enter CLI commands to make configuration changes, these changes are immediately added to the device’s running configuration but are not saved to the configuration file.

This section describes how to display the running configuration and the configuration file, and how to save and load configuration changes. A procedure is also provided for resetting the WSS switch to its factory default configuration.

320657-A