Configuring AP access points 269

To change the RTS threshold, use the following command:

set radio-profile name rts-threshold threshold

The threshold can be a value from 256 bytes through 3000 bytes. The default is 2346.

To change the RTS threshold for radio profile rp1 to 1500 bytes, type the following command:

23x0# set radio-profile rp1 rts-threshold 1500

success: change accepted.

Changing the Fragmentation Threshold

The fragmentation threshold specifies the longest a frame can be without being fragmented into multiple frames by a radio before transmission. To change the fragmentation threshold, use the following command:

set radio-profile name frag-threshold threshold

The threshold can be a value from 256 through 2346. The default is 2346.

To change the fragmentation threshold for radio profile rp1 to 1500 bytes, type the following command:

23x0# set radio-profile rp1 frag-threshold 1500

success: change accepted.

Changing the Short Retry Threshold

The short retry threshold specifies the number of times a radio can send a short unicast frame without receiving an acknowledgment for the frame. A short unicast frame is a frame that is shorter than the RTS threshold.

To change the short retry threshold, use the following command:

set radio-profile name short-retry threshold

The threshold can be a value from 1 through 15. The default is 5.

To change the short retry threshold for radio profile rp1 to 3, type the following command:

23x0# set radio-profile rp1 short-retry 3

success: change accepted.

Changing the Long Retry Threshold

The long retry threshold specifies the number of times a radio can send a long unicast frame without receiving an acknowledgment for the frame. A long unicast frame is a frame that is equal to or longer than the RTS threshold.

To change the long retry threshold, use the following command:

set radio-profile name long-retry threshold

The threshold can be a value from 1 through 15. The default is 5.

To change the long retry threshold for radio profile rp1 to 8, type the following command:

23x0# set radio-profile rp1 long-retry 8

success: change accepted.

Nortel WLAN Security Switch 2300 Series Configuration Guide

Page 269
Image 269
Nortel Networks 2300 manual Set radio-profile name rts-threshold threshold, 23x0# set radio-profile rp1 rts-threshold