254Configuring AP access points

AP Parameters:

set dap auto

mode {enable disable}

set dap auto

bias {high low}

set dap auto

upgrade-firmware {enable disable}

set

dap

auto

group name

set

dap

auto

blink {enable disable}

Radio Parameters:

set dap auto radiotype {11a 11b11g}

set dap auto

radio {1 2}

mode {enable disable}

set dap auto

radio {1

2}

radio-profile name mode {enable disable}

set dap auto

radio {1

2}

auto-tune max-power power-level

set

dap

auto

radio

{1

2}

auto-tune

max-retransmissions retransmissions

set

dap

auto

radio

{1

2}

auto-tune

min-client-rate rate

Enabling the Template

To enable the template for automatic Distributed AP configuration, type the following command:

23x0# set dap auto mode enable

success: change accepted.

Specifying the Radio Profile Used by the Template

The template uses radio profile default by default. To use another radio profile instead, use the following command:

set dap auto radio {1 2} radio-profile name mode {enable disable}

The following command changes the template to use radio profile autodap1 for radio 1:

23x0# set dap auto radio 1 radio-profile autodap1

success: change accepted.

Note. You must configure the radio profile before you can apply it to the template.

Displaying Status Information for APs Configured by the Template

To display status information for APs configured by the template, type the following command:

23x0# show dap status auto

Dap:100(auto),IP-addr:10.8.255.6(vlan'default'),APmodel:AP-2330, manufacturer: Nortel, name: DAP100

====================================================

State: operational

320657-A

Page 254
Image 254
Nortel Networks 2300 manual 23x0# set dap auto mode enable, 23x0# set dap auto radio 1 radio-profile autodap1