Nortel Networks 2300 Radius and Server Group Configuration Scenario, Deleting a Server Group

Configuring Communication with RADIUS 487

Deleting a Server Group

To remove a server group, type the following command:

clear server group group-name

For example, to delete the server group shorebirds, type the following command:

23x0# clear server group shorebirds

success: change accepted.

The members of the group remain configured, although no server groups are shown:

23x0# show aaa Default Values

authport=1812 acctport=1813 timeout=5 acct-timeout=5 retrans=3 deadtime=0 key=(null) author-pass=(null)

Radius Servers
Server	Addr	Ports T/o Tries Dead State

-------------------------------------------------------------------

sandpiper	192.168.253.3	1812	1813	5	3	0	UP
heron	192.168.253.1	1812	1813	5	3	0	UP
coot	192.168.253.4	1812	1813	5	3	0	UP
egret	192.168.253.2	1812	1813	5	3	0	UP
Server groups

RADIUS and Server Group Configuration Scenario

The following example illustrates how to declare four RADIUS servers to an WSS switch and configure them into two load-balancing server groups, swampbirds and shorebirds:

1Configure RADIUS servers. Type the following commands:

23x0# set radius server pelican address 192.168.253.11 key elm 23x0# set radius server seagull address 192.168.243.12 key fir 23x0# set radius server egret address 192.168.243.15 key pine

23x0# set radius server sandpiper address 192.168.253.17 key oak

2Place two of the RADIUS servers into a server group called swampbirds. Type the following command:

23x0# set server group swampbirds members pelican seagull

3Enable load balancing for swampbirds. Type the following command:

23x0# set server group swampbirds load-balance enable

4Place the other RADIUS servers in a server group called shorebirds. Type the following command:

23x0# set server group shorebirds members egret pelican sandpiper

Nortel WLAN Security Switch 2300 Series Configuration Guide