Nortel Networks 2300 manual Displaying Remote Traffic Monitoring Statistics

594Appendix A: Troubleshooting a WS Switch

Displaying Remote Traffic Monitoring Statistics

The AP collects statistics for packets that match the enabled snoop filters mapped to its radios. The AP retains statistics for a snoop filter until the filter is changed or disabled. The AP then clears the statistics.

To display statistics for packets matching a snoop filter, use the following command:

show snoop stats [filter-name[dap-num[radio {1 2}]]]

The following command shows statistics for snoop filter snoop1: 23x0# show snoop stats snoop1

Filter Dap Radio Rx Match Tx Match Dropped Stop-After

===============================================================================

snoop1 3 1 96 4 0 stopped

Preparing an Observer and Capturing Traffic

To observe monitored traffic, install the following applications on the observer:

•Ethereal or Tethereal Version 0.10.8 or later

•Netcat (any version), if not already installed

Ethereal and Tethereal decode 802.11 packets embedded in TZSP without any configuration.

Use Netcat to listen to UDP packets on the TZSP port. This avoids a constant flow of ICMP destination unreachable messages from the observer back to the radio. You can obtain Netcat through the following link:

http://www.securityfocus.com/tools/139/scoreit

If the observer is a PC, you can use a Tcl script instead of Netcat if preferred.

1Install the required software on the observer.

2Configure and map snoop filters in WSS Software.

3Start Netcat, using a command such as the following: nc -l-u-p 37008 ip-addr > /dev/null &

Where ip-addris the IP address of the Distributed AP to which the snoop filter is mapped. (To display the Distributed AP’s IP address, use the show dap status command.)

4Start the capture application:

●For Ethereal capture, use ethereal filter port 37008.

●For Tethereal capture, use tethereal -V port 37008.

5Disable the option to decrypt 802.11 payloads. Because the AP always decrypts the data before sending it to the observer, the observer does not need to perform any decryption. In fact, if you leave decryption enabled on the observer, the payload data becomes unreadable.

To disable the decryption option in Ethereal:

a In the decode window, right-click on the IEEE 802.11 line.

b Select Protocol Preferences to display the 802.11 Protocol Preferences dialog.

c Click next to Ignore the WEP bit to deselect the option. This option is applicable for any type of data encryption used by AP radios.

320657-A