Nortel Networks 2300 manual Displaying RF Auto-Tuning Settings, 23x0# show radio-profile default

Configuring RF Auto-Tuning 301

Displaying RF Auto-Tuning Settings

To display the RF Auto-Tuning settings that you can configure in a radio profile, use the following command:

show radio-profile {name ?}

Entering show radio-profile ? displays a list of radio profiles.

To display the RF Auto-Tuning and other settings in the default radio profile, type the following command:

23x0# show radio-profile default

Beacon Interval:	100	DTIM Interval:	1
Max Tx Lifetime:	2000	Max Rx Lifetime:	2000
RTS Threshold:	2346	Frag Threshold:	2346
Short Retry Limit:	5	Long Retry Limit:	5
Long Preamble:	NO	Allow 802.11g clients only:	NO
Tune Channel:	yes	Tune Power:	no
Tune Channel Interval:	3600	Tune Power Interval:	600
Power Backoff Timer:	10	Channel Holddown:	300
Countermeasures:	none	Active-Scan:	yes
WMM enabled:	yes

Service profiles: default-dot1x, default-clear

To display the RF Auto-Tuning settings that you can configure on an individual radio, use the following commands:

show ap config [port-list[radio {1 2}]] show dap config [dap-num[radio {1 2}]]

To display the RF Auto-Tuning and other individual radio settings on radio 1 of a directly connected AP access point connected to WSS port 2, type the following command:

23x0# show ap config 2 radio 1

Port 2: AP model: AP-352, POE: enable, bias: high, name: AP02 boot-download-enable: YES

load balancing group: none

Radio 1: type: 802.11g, mode: disabled, channel: 6

tx pwr: 1, profile: default

auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10

To display the RF Auto-Tuning and other individual radio settings on both radios on the Distributed AP access point configured on connection 1, type the following command:

23x0# show dap config 1

Dap 1: serial-id: 12345678, AP model: AP-352, bias: high, name: DAP01 fingerprint: b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3 boot-download-enable: YES

load balancing group: none

Radio 1: type: 802.11g, mode: disabled, channel: 6

tx pwr: 1, profile: default

auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10

Radio 2: type: 802.11a, mode: disabled, channel: 36

tx pwr: 1, profile: default

auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10

Nortel WLAN Security Switch 2300 Series Configuration Guide