Nortel Networks 2300 manual Configuring AP access points

Configuring AP access points 247

Configuring AP access points

To configure AP access points, perform the following tasks, in this order:

•Specify the country of operation. (See “Specifying the Country of Operation” on page 248.)

•Configure a template for automatic configuration of Distributed APs. (See “Configuring a Template for Automatic AP Configuration” on page 251.)

•Configure AP access points and dual homing. (See “Configuring AP Port Parameters” on page 256.)

•Configure AP-WSS security. (See “Configuring AP-WSS Security” on page 261.)

•Configure a service profile to set SSID and encryption parameters. (See “Configuring a Service Profile” on page 265.)

•Configure a radio profile. (See “Configuring a Radio Profile” on page 267.)

•If required, configure the channel, transmit power, and external antenna type on each radio. (See “Configuring Radio-Specific Parameters” on page 273.)

•Map the radio profile to a service profile. (See “Mapping the Radio Profile to Service Profiles” on page 276.)

•Assign the radio profile to radios and enable the radios. (See “Assigning a Radio Profile and Enabling Radios” on page 277.)

Nortel WLAN Security Switch 2300 Series Configuration Guide