Configuring AAA for Administrative and Local Access 57

Enabling an Administrator

To enable yourself as an administrator, you must log in to the WSS from the console. Until you set the enable password and configure authentication, the default username and password are blank. Press Enter when prompted for them.

To enable an administrator:

1Log in to the WSS from the serial console, and press Enter when the WSS displays a username prompt:

Username:

2Press Enter when the WSS displays a password promptprompt.

Password:

3Type enable to go into enabled mode.

23x0> enable

4Press Enter to display an enabled-mode command prompt:

23x0#

Once you see this prompt after you have typed the enable command, you have administrative privileges, which allow you to further configure the WSS.

Nortel WLAN Security Switch 2300 Series Configuration Guide

Page 57
Image 57
Nortel Networks 2300 manual Enabling an Administrator, Username, Password, 23x0 enable, 23x0#