Nortel Networks 2300 manual Specifying the Country of Operation, Set system countrycode code

248Configuring AP access points

Specifying the Country of Operation

You must specify the country in which you plan to operate the WSS switch and its AP access ports. WSS Software does not allow you to configure or enable the AP access point radios until you specify the country of operation.

Note. In countries where Dynamic Frequency Selection (DFS) is required, WSS Software performs the appropriate check for radar. If radar is detected on a channel, the AP radio stops using the channel for the amount of time specified in the specified country’s regulations. WSS Software also generates a log message to notify you when this occurs.

To specify the country, use the following command:

set system countrycode code

For the country, you can specify one of the codes listed in Table 12.

Table 12: Country Codes

Country	Code
Australia	AU
Austria	AT
Belgium	BE
Brazil	BR
Canada	CA
China	CN
Czech Republic	CZ
Denmark	DK
Finland	FI
France	FR
Germany	DE
Greece	GR
Hong Kong	HK
Hungary	HU
Iceland	IS
India	IN
Ireland	IE
Israel	IL
Italy	IT
Japan	JP

320657-A