282Configuring AP access points

Displaying AP Configuration Information

To display configuration information, use the following commands:

show ap config [port-list[radio {1 2}]] show dap config [dap-num[radio {1 2}]]

The command lists information separately for each AP access port.

To display configuration information for an AP access point on WSS port 2, type the following command:

23x0# show ap config 2

Port 2: AP model: 2330, POE: enable, bias: high, name: AP02 boot-download-enable: YES

load balancing group: none

Radio 1: type: 802.11g, mode: disabled, channel: 6

tx pwr: 1, profile: default

auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10 Radio 2: type: 802.11a, mode: disabled, channel: 36

tx pwr: 1, profile: default

auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10

To display configuration information for a Distributed AP access point configured on connection 1, type the following command:

23x0# show dap config 1

Dap 1: serial-id: 12345678, AP model: 2330, bias: high, name: DAP01 fingerprint: b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3 boot-download-enable: YES

load balancing group: none

Radio 1: type: 802.11g, mode: disabled, channel: 6

tx pwr: 1, profile: default

auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10 Radio 2: type: 802.11a, mode: disabled, channel: 36

tx pwr: 1, profile: default

auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10

(For information about the fields in the output, see the Nortel Mobility System Software Command Reference.)

320657-A

Page 282
Image 282
Nortel Networks 2300 manual Displaying AP Configuration Information, 23x0# show dap config