Nortel Networks 2300 manual Port parameter Setting

		Configuring AP access points 257
Table 16: AP Access Port Defaults
	Port parameter	Setting
	VLAN membership	Port is removed from all VLANs. You cannot assign an AP
		access point to a VLAN. WSS Software automatically assigns
		AP access points to VLANs based on user traffic.
	Spanning Tree Protocol (STP)	Not applicable
	802.1X	Port uses authentication parameters configured for users.
	Port groups	Not applicable
	IGMP snooping	Enabled as users are authenticated and join VLANs.
	Maximum user sessions	Not applicable

Warning! When you set the port type for AP use, you must specify the PoE state (enable or disable) of the port. Use the WSS switch’s PoE to power Nortel AP access ports only. If you enable PoE on a port connected to another device, physical damage to the device can result.

Note. You cannot configure port 7 or 8 on an WSS-2360 switch, or port 1 on an WSS-2350 , or any gigabit Ethernet port, as an AP port. To manage an AP access point on an WSS-2380 switch, configure a Distributed AP connection on the switch. (See “Configuring an Indirectly Connected AP” on page 258.)

To set the port type for AP access points, use the following command:

set port type ap port-list

model {AP2750 AP-52 AP-101 AP-122 AP-241 AP-252 AP-262 AP-341 AP-352 2330}

poe {enable disable}

[radiotype {11a 11b11g}]

You must specify the AP model and the PoE state.

Note. All AP models except the 2330 and AP2750 have been discontinued but are still supported by the command.

For models AP-101, AP-241, and AP-341, you can specify one of the following for the radio type:

•11a—802.11a

•11b—802.11b

•11g—802.11g (AP-241 and AP-341 only)

Nortel WLAN Security Switch 2300 Series Configuration Guide